NETGEAR WG111U User Manual page 34

User's Manual for the NETGEAR Super AG Wireless USB 2.0 Adapter WG111U
Install the NETGEAR Super AG Wireless
USB 2.0 Adapter WG111U.
Locate an available USB port on your
a.
PC. Connect the USB cable to the
WG111U and insert the other end of the
cable into the USB slot on your PC.
After a short delay, the Found New
b.
Hardware Wizard displays. The first
time that you install the WG111U on a
computer, the wizard will install the
bootloader device. Follow the
installation prompts.
Note: Click Yes if you are prompted
with a Digital Signature Not Found
message.
After the bootloader device is installed,
c.
the Found New Hardware Wizard will
display again and install the WG111U.
Follow the installation prompts.
Note: Click Yes if you are prompted
with a Digital Signature Not Found
message.
Click Finish when done, and if
d.
prompted restart your computer.
You will see the WG111U system tray
icon on the lower right portion of the
Windows task bar.
3-10
Found New Hardware Wizard
Note: If your computer does not have a USB v2.0
port but rather a USB v1.1 type port, the WG111U
will be limited to the maximum speed of the USB
v1.1 port. USB v1.1 port maximum speed is 12
Mbps whereas the maximum speed of a USB v2.0
port is 480 Mbps.
WG111U System Tray Icon
202-10065-01
Basic Setup