NETGEAR WG111U User Manual page 22

User's Manual for the NETGEAR Super AG Wireless USB 2.0 Adapter WG111U
Table 2-1. A Road Map for How to Get There From Here
If I Want To? What's Needed?
Connect to the 1. An active Internet
Internet over the connection like those from
wireless cable or DSL service
network. providers.
2. A wireless network
connected to the cable or
DSL Internet service
through a cable/DSL
router as illustrated in
"Connecting to an Access
Point in Infrastructure
Mode" on page
3. TCP/IP Internet
networking software
installed and configured
on your PC according to
the requirements of the
Internet service provider.
4. A browser like Internet
Explorer or Netscape
Navigator.
2-6
What Do I Do?
1. Activate your
wireless link and
verify your network
connection.
2. Open an Internet
browser such as
Internet Explorer
or Netscape
Navigator.
4-2.
202-10065-01
How Do I?
To configure your WG111U in
Infrastructure Mode, see
Installation Instructions" on
page 3-4, and locate the section
for your version of Windows.
For assistance with configuring
the TCP/IP Internet software on
a PC, see "Preparing Your
Computers for TCP/IP
Networking" on page C-4
to the PC Networking Tutorial on
the NETGEAR Super AG
Wireless USB 2.0 Adapter
WG111U Resource CD and the
Help information provided in the
Windows system you are using.
.
Introduction
"Basic
or refer