Eden wp100 Quick Start Manual page 13

WT550 Back Panel Navigation:
1. Power Inlet / Fuse Holder: Insert supplied power cord.
2. Speakon output: Connect your amplifier to a single
speaker cabinet.
3. Speaker output 1: Connect your amplifier to a speaker.
4. Speaker output 2: Connect your amplifier to a second
speaker.
5. Effects send: Take your signal for an external processor or
effects chain.
6. Effects return: Return your signal from your external
processor or effects chain.
7. DI level control: Adjust the DI output level.
8. Recording DI out: Take your DI line for a recording console
or desk from.
9. Ground lift switch: Turns ground lift function off/on.
10. Aux input (R): Input your right auxiliary input signal.
11. Aux input (L): Input your left auxiliary input signal.
12. Tuner Output: Connect your external tuner.
IMPORTANT: Your amplifier has been engineered and built to function only for the voltage shown on the rear of the unit. To
use this unit under different voltage conditions you will either require a suitable power conditioner or modifications to the
amplifier which should only be undertaken by qualified Eden approved engineers. In addition your unit was supplied with the
correct fuse fitted and a replacement fuse. To obtain additional replacements you should contact your nearest Eden dealer or
a qualified Eden technician.
E D E N | W O R L D T O U R S E R I E S | W T 5 5 0 - 6
H I F I D E L I T Y F O R L O W F R E Q U E N C Y | 1 3