Eden wp100 Quick Start Manual page 11

30. Limit switch: Toggles the output limiters off/on.
31. Side chain level: Controls the amount of effect return
(chain level).
32. Crossover control (active only in Bi-amp mode):
Controls the crossover point between outputs.
33. Aux level control: Controls the level of auxiliary inputs.
34. Balance control: Balances the levels of the output signals.
35. Left output indicator: Displays the output level of the
left channel.
WP100 Back Panel Navigation:
1. Ground lift L/R switch: Switch ground lift feature off/on for
L/R channels.
2. Ground Lift DI switch: Switch ground lift feature off/on for
XLR Recording DI output.
3. Power Inlet / Fuse Holder: Insert supplied power cord.
4. Main Outputs: Take you main left and right output signals
from these connections.
5. Aux Inputs: Input your left and right auxiliary input signals.
6. Main DI left: Take left channel DI Signal from.
7. Return inputs: Input your left and right return signals from an
external processor or effects chain.
8. Main DI right: Take right channel DI Signal from.
9. Send outputs: Take your left and right signals for an external
processor or effects chain.
IMPORTANT: Your amplifier has been engineered and built to function only for the voltage shown on the rear of the unit. To
use this unit under different voltage conditions you will either require a suitable power conditioner or modifications to the
amplifier which should only be undertaken by qualified Eden approved engineers. In addition your unit was supplied with the
correct fuse fitted and a replacement fuse. To obtain additional replacements you should contact your nearest Eden dealer or
a qualified Eden technician.
E D E N | W O R L D T O U R S E R I E S | W P 1 0 0 - 5
36. Right output indicator: Displays the output level of the
right channel.
37. Master control: Adjusts the overall output level of the unit.
38. Stereo phones: Insert your stereo headphones.
39. Main switch: Turn your WP100 off/on.
10. Recording DI out: Take your DI line for a recording console
or desk from.
11. Side chain: Return (in) and Send (out) connections for side
chain signals.
12. Footswitch: Connect your WP100 Eden Foot switch.
13. Pre effects loop: Return and Send connections for Pre
EQ effects.
14. Tuner Out: Connect your rack or foot pedal tuner.
H I F I D E L I T Y F O R L O W F R E Q U E N C Y | 1 1