Water Inlet Hose Connection - Beko DFN2000X User Manual

Water inlet hose connection

Make sure your plumbing is suitable
to install your new dishwasher. If in
doubt contact a qualified plumber.
The appliance must be connected
to the water mains using the new
hose set supplied with your new
dishwasher. Old hose sets must
not be re-used.
The water pressure coming from
the water mains supply must be a
minimum of 0.3 and a maximum of 10
bars.
Connect the straight end to your
water mains supply
filter and black rubber seal is in place.
Please turn on the tap and check for
leakages after connecting the hose.
We recommend the tap is turned off
when the machine is not being used.
If you only have one cold water
feed (For example for your washing
machine) don't worry, a Y adaptor
will provide you with the additional
cold water feed you need for your
dishwasher. Y adaptor is available
from most DIY stores.
1
Ensure plastic
1
3/4”
AQUASAFE+
The Aquasafe+ System protects
against water damage which may be
caused at the water inlet hose.
Do not immerse the system's valve
box into water; it contains electrical
components.
In case of damage, pull out the power
supply plug.
Do not shorten or lengthen the hose
insert as it contains electrical cables
and components.
9 GB
min 10
AQUASAFE+