Connecting The Digital Entertainer - NETGEAR Digital Entertainer EVA700 User Manual

Connecting the Digital Entertainer

If you are using a Windows XP computer without Intel® Viiv™ technology,
connect the digital entertainer first, and install the software as explained in
"Windows XP Computer Without Intel® Viiv™ Technology" on page 1-8.
If you are using an Intel® Viiv™ technology, then you must update the software
before you connect the digital entertainer. See Chapter 2, "Intel® Viiv™
Technology".
The digital entertainer is compatible with the following types of video and audio
cables:
•
•
•
The rear view of the digital entertainer is shown below:
SCART
Figure 1-4
Follow these steps to connect the digital entertainer.
1. Connect the digital entertainer to your television set and audio equipment. If
you use a digital a/v receiver, use S/PDIF coaxial cable to connect it.
2. Connect the digital entertainer to the router with an Ethernet cable.
Installing Your Digital Entertainer
Video cable and Audio cable: These two cables are included, and are
compatible with most televisions in the U.S.
SCART: This cable is often used in Europe and Australia, and is not
included in the package. However, if you have a SCART cable the digital
entertainer recognizes it, and you can continue to use these instructions.
S-Video, or Component Video: These cables are not included in the
package, and you will need to change the digital entertainer settings in
order to use them.
S/PDIF
Coaxial
(audio)
S-Video
v1.0, May 2006
Digital Entertainer Model EVA700 User Manual
Composite Video
Stereo Audio
Component Video Ethernet port with LEDs
1-7