Advertisement
4.
Connect to MR3201A
Your device (laptop, desktop computer, etc.) must have a wireless network
card to be able to find and connect to WiFi networks.
If your device isn't WiFi-ready, check the User Manual in the CD to configure
MR3201A using a network cable.
Register MR3201A
1.
Find the "Wireless Network Connection" icon in your computer.
In Windows XP, it is located in the task bar (see figure).
For other operating systems, check the User Manual.
2.
Right click with your mouse on this icon and select "View available
wireless networks" and a window similar to this one will appear:
a
MR3201A sends out two WiFi signals: a public one (MR3201A_AP) and a private
one (MyPlace).
If you can't see signals, click on the "Refresh network list" button ( a ).
If the problem persists, check that you've installed MR3201A properly.
If you see MR3201A private signal but do not find the public signal, check the
User Manual, since you will need to make some network configuration
adjustments in MR3201A.
3.
MR3201A needs to be registered through public signal. Select
the "AP" signal and click on the "Connect" button ( b ).
A few seconds later you'll see a message informing that you're
connected to the "AP" signal.
4.
Open your browser (Internet Explorer, Firefox...) and you'll see
Access Portal.
5.
To access your User Zone, log in with the email and password you used
to register in the MR3201A Community.
We'll show you a specific form for you to register your access point in
the MR3201A Community.
Private
Public
b
If you don't register it, we'll show you a reminder alert in the User Zone
like the one in the figure.
5 5
Quick Installation Guide
Advertisement
