Philips 17S1AB Service Manual page 64

64 17S1AB LCD
C. Image Viewing
i. Purpose: Design for image viewing application, especially in slide show. The screen is
ii. Enhancement Point:
D. Economy
i. Purpose: Adjust brightness level for reducing power consumptions
ii. No optimization by Smart Image.
iii. Design:
E. Off
i. Purpose: No optimization by SmartImage.
ii. Design:
3.14.1.7
A. Purpose: Built-in demo mode for sales in-store demo.
B. Design:
5. Brightness level sets to maximum.
6. SmartResponse set to "High".(N/A for this model)
7. Gamma Table turn off to achieve
8. Fastest response time. (N/A for this model)
9. Smart Contrast set to "On"
10. Gamma set to 2.4.
dominated by picture. Power point presentation could use this profile also.
1. Dynamic contrast enhancement by histogram analysis (DLC) should be off.
2. Sharpness and color to be enhanced 75%.
3. Color temperature 6500°K
4. Brightness level sets to maximum.
5. Smart Response set to "Off". (N/A for this model)
6. Smart Contrast set to "Off".
1. Brightness level set to 70%, a little higher brightness level than laptop PC, fine
tune brightness level before DVT exit.
2. Color temperature set to 6500K.
3. Gamma Table is turn on.
1. This will follow user OSD setting. If any change by user, it will be saved. When
switch back from other SmartImage profiles, it will go back to last saved
setting.
2. Gamma Table is turn on to reduce bad color tracking.
Demo mode