Generac Power Systems GN-220 Owner's Manual page 13

(3) Any warranted part that is scheduled for replacement as required maintenance in the written instructions required by
subsection (d) must be warranted for the period of time prior to the first scheduled replacement point for the part. If
that part fails prior tot he first scheduled replacement, the part must be repaired or replaced by the engine manufac-
turer according to subsection (4) below. Any such part repaired or replaced under warranty must be warranted for the
remainder of the period prior to the first schedule replacement point for that part.
(4) Repair or replacement of any warranted part under the warranty must be performed at no charge to the owner at the
warranty station.
(5) Notwithstanding the provisions of subsection (4) above, warranty services or repairs must be provided at all manufac-
turer distribution centers that are franchised to service the subject engines.
(6) The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact
defective, provided that such diagnostic work is performed at the warranty station.
(7) The manufacturer is liable for damages to other engine components proximately caused by a failure under warranty of
any warranted part.
(8) Throughout the emissions warranty period defined in subsection (b)(2), the manufacturer must maintain a supply of
warranted parts sufficient to meet the expected demand for such parts.
(9) Any replacement part may be used in the performance of any warranty maintenance of repairs and must be provided
without charge to the owner. Such use will not reduce the warranty obligations of the manufacturer.
(10) Add-on or modified parts that are not exempted by the California Air Resources Board may not be used. The use of
any non-exempted add-on or modified parts will be grounds for disallowing a warranty claim. The manufacturer will
not be liable to warrant failures of warranted parts caused by the use of a non-exempted add-on or modified part.
(11) The manufacturer issuing the warranty shall provide any documents that describe that manufacturer's warranty proce-
dures or policies within five working days of request by the California Air Resources Board.
(d) emission warranty parts list May include:
1) Fuel Metering System
a) Carburetor and internal parts (and/or pressure
regulator or fuel injection system)
b) Air/fuel ratio feedback and control system
c) Cold start enrichment system
2) Fuel tank
a) Air Induction System
b) Controlled hot air intake system
c) Intake manifold
d) Air filter
3) Ignition System
a) Spark Plugs
b) Magneto or electronic ignition system
c) Spark advance/retard system
4) Exhaust Gas Recirculation (EGR) System
a) EGR valve body, and carburetor spacer, if appli-
cable.
b) EGR rate feedback and control system
Generac Power Systems will furnish with each new engine written instructions for the maintenance and use of the engine by the
owner.
section 5 – warranty
gsh-220 engine
5) Air Injection System
a) Air pump or pulse valve
b) Valves affecting distribution of flow
c) Distribution manifold
6) Catalyst or Thermal Reactor System
a) Catalytic converter
b) Thermal reactor
c) Exhaust manifold
7) Particulate Controls
a) Traps, filters, precipitators, and any other device
used to capture particulate emissions
8) Evaporative Emission Controls
a) Carbon Canister
b) Purge valve/solenoid
c) Associated hoses
9) Miscellaneous Items Used in Above Systems
a) Electronic controls
b) Vacuum, temperature, and time sensitive valves
and switches
c) Hoses, belts, connectors, and assemblies