Table of Contents
Advertisement
u
q
Machine Operating Buttons
q Start/stop button
Press this button to start or stop the machine.
The machine starts running slowly for the first few
stitches, it then runs at the speed set by the speed control
slider. The machine runs slowly as long as this button is
pressed.
The button will turn red when the machine is running, and
green when it has been stopped.
Pressing and holding this button while sewing will slow
down the sewing speed and the machine will stop when
the button is released.
NOTE:
• The start/stop button cannot be used when the foot
control is connected to the machine.
• You can select the desired start-up speed from
slow, medium or high (refer to page 90).
w Reverse button
• When stitch pattern U01, U04, U08-U10, Q01-Q03,
or BR01-BR05, is selected;
U:
Q:
The machine will sew in reverse as long as the
reverse button is pressed. Release the button to sew
forward.
When the machine is stopped and foot control is
disconnected, the machine will sew in reverse slowly
as long as the reverse button is pressed. Release the
button to stop the machine.
• When any other stitches are selected;
If you press the reverse button when sewing any other
patterns, the machine will immediately sew locking
stitches and automatically stop.
NOTE:
There will be particular functions of the reverse
button when stitch pattern U02, U03, B02, B13, or
B14 is selected. Refer to page 28, 42, 48 and 80 for
instructions.
i
t
y
r
e
w
BR:
e Auto-lock button
• When stitch pattern U01, U04, U08-U10, Q01-Q03,
or BR01-BR05, is selected;
U:
Q:
Press the auto-lock button to sew a locking stitch
immediately. The machine will automatically stop.
When the machine is stopped, press the auto-lock
button to blink the LED signal u. The machine will
immediately sew locking stitches and automatically
stop when the machine is started.
• When any other stitches are selected;
Press the auto-lock button to sew a locking stitch
at the end of current pattern. The machine will
automatically stop.
When the machine is stopped, press the auto-lock
button to blink the LED signal u. The machine will
sew a locking stitch at the end of the current pattern
and automatically stop when the machine is started.
The machine will trim the threads automatically after
locking the stitch when the auto thread cutting is
turned on (refer to page 91).
r Needle up/down button
Press this button to bring the needle bar up or down.
The machine will stop with the needle in down position.
However, you can change the needle stop position in the
machine setting mode (refer to page 89).
t Presser foot lifter button
The presser foot will go up or go down by pressing this
button.
You can also use the presser foot lifter and knee lifter to
raise and lower the presser foot (refer to page 21).
y Thread cutter button
After finish sewing, press this button to trim the threads.
The needle bar automatically rises after trimming the
threads (refer to page 27).
The LED signal i blinks when the machine trims
threads.
NOTE:
The thread cutter button does not function:
- directly after turning on the power.
- when the presser foot is raised with the foot lifter.
- after being pressed 3 times in a row.
Use the thread cutter on the face cover if the thread is
#30 or thicker (refer to page 27).
8
BR:
Advertisement
Table of Contents
