Hdd Setup - Samsung SHR-5040 User Manual

System Information & Setup
system information/setup
mac address
software version
package search
upgrade version
remocon id
move/Control
 Mac Address
Displays the unique number of the network hardware
device attached to the system.
 software version
Displays the current software version.
 Package search
After connecting the USB device (holding the DVR
software) to a USB port, press the (
DVR software will be automatically searched. If the
DVR software does not exist in the USB device, the
upgrade version will not be displayed.
 Upgrade version
The software version to be upgraded will be shown. If
you press the "Upgrade", the restart message window
appears. You can select "Yes" to proceed with the
upgrade.
 remocon id
In order to control the DVR with a remote commander,
set the DVR and the remocon ID.
26_ menu setup
SHR-5042_Eng_02.indd 26
00:C:8C:ff:00:a9
v1.000a10
find package in usB
none upgrade
00
ok Cancel
select exit
) icon and the
 For the DVR to recognize the update file
the file should be inserted into a folder
Caution
named "update". So this folder should
be created on a USB memory and then
the upgrade file copied inside the folder.
 When upgrading the software, you must
neither turn off the power nor remove
the USB device. The system may run
abnormally.
 When using a USB memory, please
use the USB device that can support
Linux 2.6.0 or higher. The system
cannot support the device that does not
support Linux.
 The file system for the USB device must
be either FAT16 or FAT32. The system
does not support NTFS or other file
systems.
 Since some USB devices either have no
power supply or have a low voltage, a
separate power supply may be needed
to recognize them.
 When shipping this product, the remote
controller ID is set to '00'.
 When changing the remote control ID, press
"remocon id" and enter the DVR ID.

HDD Setup

hdd setup
ata info
1 primary
2
hdd end setup
recording
overwrite
off
format
 hdd info
Shows the installed HDD information and the capacity.
The first installed HDD is displayed as the Primary and
the second HDD is shown as the Secondary.
format
149gB
ok Cancel
2008-01-25 오전 9:31:20