Cutting Operations; Bevel Cut - King Canada 8320SC Instruction Manual

CUTTING OPERATIONS

CROSSCUTTING
A crosscut is made by cutting across the grain of the workpiece. A 90
made with the miter and the bevel angle set at 0
1. Pull and turn the saw head release knob (A) Fig.12 and lift the saw head to its full
height.
2. Loosen the miter lock knobs (A) Fig.4. Rotate the miter table until the pointer
aligns with the 0º. Retighten the miter lock knobs.
WARNING: Be sure to tighten the miter lock knobs before making a cut. Failure to
do so could result in the table moving during the cut and serious personal injury.
3. Place the workpiece flat on the table with one edge securely against the fence. If
the board is warped, place the convex side against the fence. If the concave side is place against the fence, the board could break and jam
the blade.
4. When cutting long pieces of timber, support the opposite end of the timber with an additional roller stand or a work surface that is level with
the saw table.
5. Use a vise or clamp to secure the workpiece whenever possible.
6. Before turning on the saw, perform a dry run of the cutting operation to check that there are no problems.
7. Hold the trigger handle firmly and squeeze the trigger (B) Fig.10. Allow the blade to reach maximum speed.
8. Slowly lower the blade into and through the workpiece.
9. Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of the workpiece. Wait until the blade stops
before removing the workpiece.

BEVEL CUT

A bevel cut is made by cutting across the grain of the workpiece with the blade angled to the fence and miter table. The miter table is set at the
0º position and the saw head is set at an angle between 0
1. Pull and turn the saw head release knob (A) Fig.12 and lift the saw head to its full height.
2. Loosen the miter lock knobs (A) Fig.4. Rotate the miter table until the pointer aligns with the 0º. Retighten the miter lock knobs.
WARNING: Be sure to tighten the miter lock knobs before making a cut. Failure to do so could result in the table moving during the cut and
serious personal injury.
3. Loosen the bevel lock knob (B) Fig.9 and move the saw arm to the desired bevel angle (between 0
lock knob.
4. Place the workpiece flat on the table with one edge securely against the fence. If the board is warped, place the convex side against the fence.
If the concave side is place against the fence, the board could break and jam the blade.
5. When cutting long pieces of timber, support the opposite end of the timber with an additional roller stand or a work surface that is level with
the saw table.
6. Use a vise or clamp to secure the workpiece whenever possible.
7. Before turning on the saw, perform a dry run of the cutting operation to check that there are no problems.
8. Hold the trigger handle firmly and squeeze the trigger (B) Fig.10. Allow the blade to reach maximum speed.
9. Slowly lower the blade into and through the workpiece.
10. Release the switch trigger and allow the saw blade to stop rotating before raising the blade out of the workpiece. Wait until the blade stops
before removing the workpiece.
OPERATIONS
0 crosscut is
0 .
0 and 45 0 to the left.
Figure 12
0 and 45 0 to the left). Retighten the bevel