LG LWS3081ST Installation Manual page 6

Electric convection built-in oven
Hide thumbs Also See for LWS3081ST:
Table of Contents

Advertisement

Available languages

Available languages

Part 2
INSTALLATION REQUIREMENTS
3
INSTALLATION DRAWINGS
The first step of the installation is measure the current cutout dimensions and compare them to the cutout
dimensions shown below. Little or no cabinet work may be necessary.
IMPORTANT NOTE
• The cabinet base platform must be able to support 190lbs (86kg). If the cabinet does not have a solid bottom, two
braces or runners must be installed level with the bottom of the cutout to support the weight of the oven.
Make sure the base is level and the front of the cabinet is square. If the cabinet base is not level, the oven glides
will tend to slide out when opening the door.
• If marks, blemishes or the cutout opening are visible above the installed oven, it may be necessary to add wood
shims under the runners and front trim until the marks or opening are covered.
• If the cabinet does not have a front frame and the sides are less than 3/4" (1.9 cm) thick, shim both sides equally
to establish the cutout width.
• The junction box must be flush with the rear wall of the cabinet as shown below.
• This oven is only approved to be installed under the specific models as labeled on this unit.
• Kitchen cabinets in contact with the oven must be heat resistant up to 194°F (90°C), and fronts of nearby units up
to at least 158°F (70°C).
Product dimensions
Dimensions are the same as the single built-in oven on page 4.
Cutout dimensions
Gas or electric cooktops may be installed over this oven.
See cooktop installation instructions for cutout size.
See label on top of oven for approved cooktop models.
25" (63.5 cm)
Top and/or side fillers
may be necessary if
unit is positioned
between existing
cabinets. Be sure they
are attached securely
since, they will anchor
the oven in the cabinets.
(FOR 30" SINGLE BUILT- IN OVEN UNDERCOUNTER)
240 V / 208 V
Junction Box Location
(Junction box may be
in adjacent cabinet)
Allow 1" (2.5 cm)
28 15/16" (73.5 cm) Min.
overlap top of oven,
29" (73.7 cm) Max.
1 1/16" (1.8 cm) overlap
side edges of cutout
and 1 1/4" (3.2 cm)
overlap bottom of oven.
28 1/2" (72.4 cm) Min.
28 5/8" (72.7 cm) Max.
- 6 -
Gas and electrical connections for
30" (76.2 cm) gas cooktop must be located
in an adjacent accessible location to the
right. For a 36" (91.4 cm) gas cooktop, the
connections may be made to the left.
5"
23 1/2" (59.7 cm) Min.
36" (91.4 cm)
Above Support
Typical
Platform
Countertop
Height
24" (61 cm)
2 3/4"(7 cm) ~ 4"(10.2 cm)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents