Section 6 - Web-Based Management; Overview; Preparation - NetComm Fast Ethernet Mini Print Server NP3640 User Manual

Section 6 - Web-Based Management

This section explains how to use your Web Browser to configure the Print Server models

Overview

The Print Server models incorporate the HTTP server. This allows you to connect to the Print
Server and configure it using your Web Browser. Most browsers should work, provided they
support tables and forms.

Preparation

Because it supports dynamic IP Address allocation using DHCP, BOOTP, or RARP, the Print
Server ships with an IP Address of 0.0.0.0. This is NOT a valid IP Address.
Therefore, you must do ONE of the following:
Check your DHCP server (if you have one), and determine the IP Address allocated to the
Print Server .
Use the Diagnostic Button (if fitted) to print a report which includes the current IP address.
(Press the Diagnostic Button, and hold it for 2 seconds.)
Use the Setup Wizard, BiAdmin or another Print Server utility to allocate a valid IP Address
to the Print Server .
Add an entry to the arp table to associate the hardware address of the Print Server with the
desired IP address, as follows:
arp -s IP_Address 00:c0:02:xx:xx:xx
arp -s IP_Address 00-c0-02-xx-xx-xx
Where:
IP_Address is the IP Address you wish to assign to the Print Server .
00:c0:02:xx:xx:xx is the hardware address of the Print Server .
Example (Unix):
arp -s 192.168.0.21 00:c0:02:12:34:56
Example (Windows):
arp -s 192.168.0.21 00-c0-02-12-34-56
Note: The hardware address of the Print Server is shown on a sticker on the base of
the device.
Rev. 1 - YML657
NP3640 Fast Ethernet Mini Print Server User Guide
(Unix)
(Windows)
www.netcomm.com.au
Page 37