Operation Procedure - NEC N920E Operating Instructions Manual

N920E(¿ )-861H0S 02.2.8 6:15 PM ˘ ` 7

OPERATION PROCEDURE

This section includes useful information about oven operation.
1. Plug power supply cord into a 230V 50Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
1
The oven light is on only when the microwave
oven is operating.
2
The oven door can be opened at any time during
operation by touching the door release button on
the control panel. The oven will automatically
shut off.
3 Each time a pad is touched, a BEEP will sound
to acknowledge the touch.
4 The oven automatically cooks on full power
unless set to a lower power level.
5
The display will show " : 0" when the oven is
plugged in.
6 Time clock returns to the present time when the
cooking time ends.
WATTAGE OUTPUT CHART
• The power-level is set by pressing the Power pad. The chart shows the display, the power level and the
percentage of power.
Touch Power pad
once
twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
7
When the STOP/CLEAR pad is touched during the
oven operation, the oven stops cooking and all
information retained. To erase all
information(except the present time), touch the
STOP/CLEAR pad once more. If the oven door is
opened during the oven operation, all information
is retained.
8
If the START pad is touched and the oven does
not operate, check the area between the door and
door seal for obstructions and make sure the door
is closed securely. The oven will not start cooking
until the door is completely closed or the program
has been reset.
Make sure the oven is properly installed and
plugged into the electrical outlet.
Power level (Display)
P-HI
P-90
P-80
P-70
P-60
P-50
P-40
P-30
P-20
P-10
P-00
7
Approximate Percentage of Power
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%