Table of Contents
Advertisement
To have a good drying we
suggest you to do not set a
too low spin speed for the
items to be washed and
dried.
2. After some seconds the display
shows the total duration of the
cycles:
Final time value (washing + drying
+ anti-crease + cooling phases)
If you set a drying time of
only 10 minutes, the final
time value includes also the
anti-crease and the cooling
phases.
3. Press button Start/Pause to start the
programme.
The door is locked.
The display shows the new time value
each minute.
11.4 At the end of the drying
programme
1. The appliance stops automatically.
2. The acoustic signals operate (if they
are active).
3. In the display
4. The indicator of button Start/Pause
goes off.
5. The last minutes of the drying cycle
the appliance performs the anti-
crease phase.
The anti-crease symbol
The door is still locked (the symbol
is on).
6. Press button On/Off for some
seconds to deactivate the appliance.
After some minutes from
the end of the
programme, the energy
saving function
automatically
deactivates the
appliance.
comes on.
flashes.
7. When the door locked light
off you can open the door.
8. Remove the laundry from the
appliance. Make sure that the drum
is empty.
9. Keep the door ajar, to prevent
mildew and odours.
10. Close the water tap.
11.5 Fluff in the fabrics
During the washing and/or drying phase,
some types of fabric, (sponge, wool,
sweatshirt) could release fluff.
The released fluff could stick to the
fabrics during the next cycle.
This inconvenient increases with
technical fabrics.
To prevent the fluff in your laundry, we
recommend that you:
• To do not wash dark fabrics after you
washed and dried light coloured
fabrics (new sponge, wool, sweatshirt )
and the contrary.
• To dry this type of fabrics at open air
when they are washed the first time.
• To clean the drain filter.
• After the drying phase, clean the
empty drum, the gasket and the door
with a wet cloth.
11.6 How to remove the fluff
in the garments
To remove the fluff inside the drum, set a
special programme:
1. Empty the drum.
2. Clean the drum, the gasket and the
door with a wet cloth.
3. Set the rinse programme.
4. Press at the same time Spin and
Extra Rinse to activate the cleaning
function until the display shows CLE.
5. Press Start/Pause to start the
programme.
ENGLISH
25
goes
Advertisement
Table of Contents
