Intended Use - Worx WG708E Original Instructions Manual

INTENDED USE

This product is intended for domestic lawn
mowing.
ASSEMBLy
ImPORTANT! Before you assemble
the lawn mower, check the accessories
according above information, make sure the
accessories are completed.
1. FITTING ThE hANDLE (See A1- A5)
1) Remove the screws (X 2) on the both side
of deck. (Fig A1)
2) Insert the lower handle (8) into the holes on
the deck provided.(Fig A2)
3) Secure with the screws provided.(Fig A2)
4) Attach the upper handle (6) with the bolts
and lock cam lever (7) to the lower handle
(8). (Fig A3)
5) Tightening the two Lock cam levers. Check
that the handle is FULLY secured.
The cam lever pressure can be adjusted by
adjusting the lock cam lever (7) clockwise/
counter-clockwise. DO NOT OVER TIGHTEN.
(Fig A4)
NOTE: Ensure the bolts are fully inserted
through the handles before fitting the handle
knobs.
6) Attach the cable clips (2) provided, to the
upper and lower handle. Insert the cable
into the clips ensuring there is enough
cable slack. (Fig A5)
2. hANDLE ADJUSTmENT (See b1,b2,
b3)
The upper handle can be adjusted to 3
different height positions. Release the locking
cam lever (7), set the upper handle to one of
the three height positions, and make sure to
insert the pin into the hole. Then reset the
locking cam lever (7).
NOTE: Always check that the upper handle is
fixed firmly.
3. GRASS COLLECTION bAG ASSEmbLy
Connect the grass box handle to the box top
as shown in F ig C1-C4.
Step 1. Press the front of the handle briefly.
Electric lawn mower
(Fig C2)
Step 2. Then push it forward. (Fig C2)
Step 3. Push down the back of the handle. (Fig
C2)
Step 4. Finally, clip the plastic clips over the
metal frame. (Fig C3)
wARNING: Don't fit the handle in
reversed direction. Fit the handle as
shown in Fig C1.
4. GRASS COLLECTION bAG FITTING
(See D1, D2, D3)
1) Unplug tool, and wait for blade to come to
a complete stop.
2) Raise the safety flap (9) and hold it up,
ensure that the mulching plug has been
removed.
3) Pick up the grass bag by the handle, and
position grass bag on the lower hooks (a)
on the mower deck (Fig. D2).
4) Release the safety guard to lock the grass
bag into position. Ensure the grass bag is
installed securely (Fig. D3).
NOTE: Depress the grass bag slightly to
ensure that it is completely installed.
5. REmOVING/EmPTyING
Hold the grass bag, lift the safety flap (9) and
hold up. Remove grass bag (4).
wARNING: Always check the safety
flap can close the discharge outlet tightly
before using. Never lift the safety flap (9)
when the lawn mower is being used without
fitted grass bag.
OPERATION
1. STARTING AND STOPPING (See E1, E2)
STARTING
Connect the plug to the mains and switch ON.
The switch box is provided with a lock-
off button to prevent accidental starting.
With one hand press and hold the safety
button (5), with the other hand squeeze the
switch lever (1) towards the handle, and
release the safety lock off button. The machine
is now started; wait until the product is at full
speed before cutting the grass. Then use both
your hands to hold the switch lever to keep it
running.
11
EN