Event Messages - SMA SUNNY BOY3000TL-US Installation Manual

9 Troubleshooting

9.2 Event Messages

Display message
Set parameter
Parameter set successfully
Update file OK
Reading SD card
No new update on the SD card There are no update files relevant for this inverter on the SD card
Update communication
Update main CPU
Update RS485i module
Update Speedwire
Update Webconnect
Upd. language table
Update completed
Grid param. unchanged
The AFCI self-test was successful The inverter has successfully performed the electric arc detection
Grid Guard code valid
Self-test
Stand-alone Op.
Back-up operation on
62 SB3-5TLUS22-IA-en-10
Cause
The inverter is setting the parameters.
A new country data set has been configured.
The update file found is valid.
The inverter is currently reading the SD card.
or the available update has already been carried out.
The inverter is updating the communication component.
The inverter is updating the inverter component.
The inverter is updating the RS485i module.
The inverter is updating the Speedwire module.
The inverter is updating the Webconnect module.
The inverter is updating the language table.
The inverter has successfully completed the update.
The selected rotary switch position is not assigned or it is not
possible to change the grid parameters.
self-test.
The SMA Grid Guard code entered is valid. Protected parameters
have now been unblocked and you can adjust the parameters.
The parameters will be automatically locked again after
10 feed-in hours.
The self-test is being carried out.
The inverter is operating in the emergency power mode.
The inverter is operating in grid parallel operation with adjusted
grid monitoring
SMA America, LLC
Installation Manual