Right Handlebar Switches; Engine Stop Switch; Starter Button; Scroll Button - Triumph Thunderbird LT Owner's Handbook Manual

Right Handlebar Switches

1
5
cfcc

1. Engine stop switch

2. STOP position
3. RUN position

4. Starter button

5. Scroll button

Engine Stop Switch
In addition to the ignition switch being turned
to the ON position, the engine stop switch
must be in the RUN position for the
motorcycle to operate.
The engine stop switch is for emergency use.
If an emergency arises which requires the
engine to be stopped, move the engine stop
switch to the STOP position.
Note:
• Although the engine stop switch
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged
battery. Ordinarily,
ignition switch should be used to
stop the engine.
General Information
Do not leave the ignition switch in the ON
2 position unless the engine is running as
this may cause damage to electrical
3
components and will discharge the battery.
Starter Button
The starter button operates the electric
starter. For the starter to operate, the clutch
lever must be pulled to the handlebar.
Note:
4
• Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down
and a gear is engaged.
Scroll Button
The scroll button is used to operate the
following functions of the instruments:
• odometer functions (see page 28);
• trip reset (see page 28);
• clock reset (see page 29).
only the
Caution
37