Table of Contents
Advertisement
SmartPanel
Introduction
The 1Gb Intelligent L2 Switch provides two switch modes: The conventional L2 switch mode, and SmartPanel
mode. The switch can store up to two different software image, called image1 and image2. Normally, the
conventional L2 switch software image is stored in image1, and the SmartPanel software is stored in image2. You
can select which software image (image1 or image2) you want to run in switch memory. By default, the switch
software is loaded from image1. To run the SmartPanel software, you need to change a software image to image2
and reboot the switch. See additional references for configuration to select a software image.
This guide explains how to configure the switch in running the SmartPanel software. The SmartPanel provides a
simple Ethernet interface option for connecting to the network infrastructure. The number and type of configuration
options on the SmartPanel are restricted to reduce the initial setup complexity and to minimize the impact on
upstream networking devices.
Additional references
Additional information about installing and configuring the switch is available in the following guides, which are
attached in this product.
•
N8406-022A 1Gb Intelligent L2 Switch User's Guide
•
N8406-022A 1Gb Intelligent L2 Switch Application Guide
•
N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (AOS)
•
N8406-022A 1Gb Intelligent L2 Switch Command Reference Guide (ISCLI)
•
N8406-022A 1Gb Intelligent L2 Switch Browser-based Interface Reference Guide
Typographical conventions
The following table describes the typographic styles used in this guide:
Table 1 Typographic conventions
Typeface or symbol
AaBbCc123
AaBbCc123
<AaBbCc123>
[ ]
Meaning
This type depicts onscreen computer output and
prompts.
This type displays in command examples and
shows text that must be typed in exactly as
shown.
This italicized type displays in command examples
as a parameter placeholder. Replace the indicated
text with the appropriate real name or value when
using the command. Do not type the brackets.
This also shows guide titles, special terms, or
words to be emphasized.
Command items shown inside brackets are
optional and can be used or excluded as the
situation demands. Do not type the brackets.
Example
Main#
Main# sys
To establish a Telnet session, enter:
host# telnet <IP address>
Read the user guide thoroughly.
host# ls [-a]
SmartPanel 5
Advertisement
Table of Contents
