Specifications - Makita SP6000 Instruction Manual

ENGLISH
1-1. Clamping screw
1-2. Blade lower limit stopper
2-1. Quick stop button
3-1. Quick stop button
4-1. Clamping screws
4-2. Tool base
5-1. Positive stopper
6-1. Lever
7-1. Bevel angle shifting lever
8-1. Base
8-2. Cutting line
9-1. Lock-off button

SPECIFICATIONS

Max. cutting depth
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is specially intended for performing plunge cuts.
In addition, lengthways and crossways straight cuts and
mitre cuts with angles in wood can also be performed
while in firm contact with the workpiece.
Explanation of general view
9-2. Switch trigger
10-1. Speed adjusting dial
11-1. Hex wrench
12-1. Lock-off button
12-2. Locking lever
13-1. Locking lever
14-1. Hex wrench
14-2. Shaft lock
15-1. Hex bolt
15-2. Outer flange
15-3. Saw blade
15-4. Inner flange
Model
Blade diameter
at 90°
at 45°
at 48°
-1
)
Overall length
Net weight
Safety class
equipment
environmentally
END201-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 89: dB (A)
sound power level: 100 dB (A)
and its
Uncertainty: 3 dB(A)
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
compatible
EN60745.
ENE067-1
EC-DECLARATION OF CONFORMITY
Model; SP6000
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 2004/108/EC, 98/37/EC.
4
16-1. Vacuum cleaner
16-2. Dust port
18-1. Adjusting screws
19-1. Slide lever
20-1. Rip fence (Guide rule)
21-1. Rear edge of tool base
21-2. Fixed stop
23-1. Adjusting screw for 90 ﾟ
24-1. Adjusting screw for 45 ﾟ
25-1. Limit mark
26-1. Screwdriver
26-2. Brush holder cap
SP6000
165 mm
56 mm
40 mm
38 mm
2,000 - 5,200
341 mm
4.1 kg
/II
Wear ear protection.
2
.
ENF002-1
ENG005-2
ENH101-7