Table of Contents
Advertisement
Installation Guidelines
Your Whitfield Quest may be installed as:
• A freestanding stove with a pedestal placed on a non-combustible floor pad.
• A mobile home heater placed on a non-combustible floor pad, provided with a
source of outside air, bolted down and electrically grounded to the chassis of the home
(see page 31) .
• A fireplace insert set into a masonry or factory built fireplace.
INSTALLATION DISCLAIMER
This stove's exhaust system works with negative combustion chamber pressure and a slightly
positive chimney pressure. Therefore, it is imperative that the exhaust system be gas-tight and
installed correctly. Since Pyro Industries, Inc., has no control over the installation of your stove,
Pyro Industries grants no warranty, implied or stated, for the installation or maintenance of your
stove, and assumes no responsibility for any consequential damage(s).
It is strongly recommended that you have an Authorized Whitfield Dealer install your stove.
If you install the stove yourself, you should review your installation plan with the Authorized
Whitfield Dealership that sold you the stove.
STOVE INSTALLATION CHECKLIST
The following check list should be used when your Quest stove is installed. Check off each
item as it is completed.
If you haven't done so already, read the Stove & Hearth Preparation section, and follow
the instructions outlined there.
Determine the appropriate measurements and location for your installation.
Read this entire Installation Guidelines section.
Read the appropriate Venting Requirements sub-section: Insert or Freestanding.
Refer to either Typical Installations - Freestanding or Typical Installation - Insert Stove
(depending on your stove type) to find the appropriate installation.
Pre-fit all items before you install, fasten, cut holes or set up the stove permanently.
Prior to lighting your stove read the entire Safety Information Pellet Fuel Information,
andStove Operation sections.
Follow the Pre-Lighting Instructions outlined in the Stove Operation section.
Follow the appropriate lighting instructions section: see Lighting the Stove With (or
Without) FASTFIRE™ Self-Igniter (located on pages 8 and 9).
After you have begun operation of your stove, review the Routine Cleaning &
Maintenance section.
Enjoy the warmth from your new Whitfield Quest Pellet Stove!
19
Hide quick links:
Advertisement
Table of Contents
