Connection; Usage - Dali Zensor AX User Manual

4 .0 C O N N E C T I O N
The main connections is located on the back of the left ZENSOR AX speaker (see Figure 5)
1) Mains connector. Connect the supplied power cord to the mains connector and your mains
outlet.
2) Main power switch. "ON" powers up the ZENSOR AX. "OFF" turns the ZENSOR AX off
completely.
3) Fuse compartment. If the ZENSOR AX fails to power up when connected to the mains and
the POWER switch is set to ON, the fuse may have blown or be faulty. Replace the fuse
with the same type as originally supplied – see fuse type on the amplifier back plate. If
the fuse blows repeatedly, have the ZENSOR AX checked at an authorised service centre –
contact your authorised dealer.
4) Right speaker output. The red (+) terminal of the right speaker must be connected to
the red (+) terminal of the left speaker. The black (-) terminal of the right speaker must be
connected to the black (-) terminal of the left speaker (see Figure 6).
5) Volume down.
6) Volume up.
7) Source select. Press to toggle between AUX IN (Front LED = Green), OPTICAL IN (Front LED
= Yellow) and Bluetooth input (Front LED = Blue).
8) AUX IN. Analogue input via stereo mini-jack.
9) SUB OUT. Output to an active subwoofer. Works with any active subwoofer. DALI SUB E-9
F or SUB E-12 F is a perfect match for the ZENSOR AX series. Ask your local DALI dealer
for further advice.
10) OPTICAL IN. Optical input via TOSLink.
11) Bluetooth release. Disconnects the current Bluetooth connection and readies the
ZENSOR AX for a new pairing/connection.
Note: Before connecting cables or changing any connections, ALWAYS turn off your ZENSOR
AX speaker.
Note: Make sure that the bare conductors are tightly gripped by the terminals with no loose
wires which could cause a short circuit and damage the ZENSOR AX speaker (see Figure 4).
5 .0 u SAG E
When powered on for the first time the ZENSOR AX will start in Bluetooth mode. Use the Source
button on the back of the left speaker or the dedicated button on the remote to change input.
5.1 remote CoNtroL
Use the included remote control (see Figure 6) to easily control power, volume and input on
the ZENSOR AX. It is also possible to use the DALI REMOTE (Not included, contact your local
DALI dealer) with the ZENSOR AX system.
1) Power. Toggle power On/Off
2) Mute. Mute and un-mute the sound
3) Optical In. Selects the optical input
4) AUX In. Selects the AUX input
5) Bluetooth. Select the Bluetooth input
6) Volume up
7) Volume down
UK DE DK FR
13