NEC XL-6500 User Manual page 31

NOTE:
• While you are viewing a source screen, you can also select the input signal directly by pressing the INPUT "1" through "10"
button. In this case INPUT buttons function as follows:
When using the projector in stand alone operation:
Input Mode
Input Module
A
Numbers designate INPUT buttons on the remote control.
When using the projector with the ISS-6020/ISS-6020G:
INPUT 1 through 10 Selects the corresponding number slot of the ISS-6020/ISS-6020G
When using the projector with two ISS-6020/ISS-6020G or more:
To switch to another input signal, enter the master slot number, then the slave slot number by using INPUT buttons and press
ENTER.
Example:If you want to select a signal from the no.3 slot of the slave Switcher which is connected to the no.2 slot of the master Switcher, first
press the INPUT "2" button, then the INPUT "3" button and then press ENTER.
• You can switch to any input signal of NO 01 through10 on the Source Select list by holding down the CTL button and pressing
one of the INPUT buttons corresponding to the input number. To activate this function you must first select ENABLE in the Direct
Key. For further details, contact your dealer.
• If there are two or more memory locations that contain the same signal information the projector will reference the signal nearest
the beginning of the list. To select the next signal use the CURSOR
RGB S–VIDEO
VIDEO
1 2 3
COMPONENT
COMPONENT
(HDTV)
4 5
or button and press ENTER.
31
3.OPERATION
Slot Selection
10