Identifying External Components; Front Panel - D-Link des-1316 Quick Installation Manual

Identifying External Components

This chapter describes the front panel, rear panel, and LED indicators of the Switch.

Front Panel

The figure below shows the front panels of the Switch.
PoE Ports
┌――┐
└――――┘ └―――┘
LED Indicators Ethernet Ports
Front panel of the Switch
LED Indicator:
Comprehensive LED indicators display the status of the switch and the network (see the
LED Indicators chapter below).
PoE Ports (Port 1~8):
These ports are PoE Enable ports, the PoE port will automatically activated when a
compatible terminal is identified, the Switch will supply power through the Ethernet port
to the connected PoE device.
For the Legacy devices that are not yet compatible, the PoE port will not offer the power
to this device. This feature allows users to freely and safely mix legacy and Power over
LAN compatible devices on their network
These ports support network speeds of either 10Mbps or 100Mbps, and can operate in
half- and full- duplex transfer modes. These ports also supports automatic MDI/MDIX
crossover detection function gives true "plug and play" capability, just need to plug-in the
network cable to the hub directly and don't care if the end node is NIC (Network
Interface Card) or switch and hub.
Ethernet Ports (Port 9~16):
These ports support network speeds of either 10Mbps or 100Mbps, and can operate in
half- and full- duplex transfer modes. These ports also supports automatic MDI/MDIX
4