Hitachi DV 14DCL2 Service Manual page 27

(f) Mount the assembly that was reassembled in step (1)
and the assembly reassembled in step (e) above
together. (See Fig. 12.) Fit the protrusion of the Motor
Spacer [31] into the recess of the Rear Case [22],
while ensuring that the Shift Knob [37] is aligned with
the positive side of the Motor [36]. Turn the Motor
Spacer [31] clockwise as viewed from the rear of the
Motor [36] until it stops. During reassembly, make sure
that the pinions press-fitted onto the shaft of the Motor
[36] and Planet Gear (A) Set [27] mesh properly.
4. Mounting the assembly reassembled in step (3) to Housing (A).(B) Set
(a) Mount the assembly that was reassembled in step (3) above to Housing (A). Confirm that the
protrusions of the Front Case [15] and Motor Spacer [31] are engaged in the recesses of Housing (A),
and that the protrusions of Housing (A) fit into the groove of the Clutch Dial [4]. (See Fig. 13.)
Fig. 13
(b) Mount the Switch Terminal [41] to Housing (A). Insert Terminal Support (A) [43] to Housing (A), while
being careful about the positioning of internal wires of the Switch Terminal [41]. (See Fig. 14.)
(c) Mount the Pushing Button [35] to Housing (A). Confirm that the protrusion of the forward/reverse
changeover lever of the Switch Terminal [41] is inserted into the groove of the Pushing Button [35].
(d) Mount the assembly that was reassembled in step (c) above to Housing (B), and then secure both with
the nine Tapping Screw (W/Flange) D3 x 16 (Black) [38].
Protrusion
Recess
-24-
Fig. 12
Groove
Protrusion
Housing (A)
Protrusion
Recess