Hitachi DV 14DCL2 Service Manual page 25

3. Reassembly of the gear unit
(a) Apply grease (Hitachi Motor Grease No. 29, Code No. 930035) to the meshing portions of each gear.
(b) Reassemble the parts of the gear unit in order. (See Fig. 8.)
Fig. 8
Slide Ring Gear [25]
Groove
(1) Position Spring (A) [16] (4 pcs.) and Steel Ball D5 [17] (4 pcs.) as illustrated in Fig. 9.
(2) Pay attention to the direction of the groove when mounting the Slide Ring Gear [25], so that the
groove faces toward the Motor [36].
(3) Mount the Front Case [15] and Rear Case [22] so that the positioning groove matches the rib.
(4) Fit Washer (B) [30] in the Rear Case [22] so that the protrusions of Washer (B) [30] fit into the
recesses on the Rear Case [22]. Then fully turn Washer (B) [30] clockwise until it stops.
(See Fig. 10.)
Spring (A) [16]
Steel Ball D5 [17]
Washer (A) [10]
Pinion (C) [26]
Planet Gear (A) Set [27]
Pinion (B) [28]
Planet Gear (A) Set [27]
Ring Gear [18]
Carrier [19]
Planet Gear (C) Set [20]
Washer (A) [21]
First Ring Gear [29]
Washer (B) [30]
-22-
Rear Case [22]
Shift Arm [24]
Screw Set
D3 x 12 [23]