Advertisement
AUTO1
TM
Vertical Rotation Mode
The AUTO1
and used for vertical rotation, this can be handy for any indoor vertical
alignment off the rotating beam.
To operate the AUTO1 in vertical rotation mode DO NOT unlock the pendulum,
leave it in the "OFF" position, use the adjustment screw on the side mount to
level off the bubble vial on the AUTO1. Once the bubble is central in the vial
press the power button on the laser and the laser head will begin to rotate,
the rotating beam being a vertical line and the dot beam being level.
Another application where the vertical mode can be usefull is site squaring
by aligning the dot laser beam along one axis of the 90 degree square and
then using the receiver to pick up the rotating beam which is at 90 degrees
to the dot laser beam.
Laser Wavelength
Laser Class
Range with LR700 Receiver
Accuracy
Self Levelling Range
IP Dust Water Resistance
Workin Temperature
Power
Low Power
Size
Weight
6
OPERATING INSTRUCTIONS
can be placed on its side with the side mount plate attached
TM
(Manual Levelling)
635nm <1mW
II
240m diameter
±4mm/20m
±3
o
IP54
-10
C to +40
o
6 x "AA" Alkaline
Power LED Flash
132x120x160mm
1.5Kg
C
o
(in shade)
Advertisement
