Bostitch 21663B-A-E Technical Data Manual page 7

TRIGGER OPERATED TOOL:
A. With finger off the trigger, hold the tool with a firm grip on the handle.
B. Place the nose of the tool against the work surface.
C. Raise the secondary trigger device.
D. Pull the trigger to cycle the tool. Release the trigger and cycle is complete.
Warning! With the secondary trigger device raised, the tool will cycle each time the trigger is pulled!
AUTOMATIC TOOL:
A. With finger off the trigger, hold the tool with a firm grip on the handle.
B. Place the nose of the tool against the work surface.
C. Raise the secondary trigger device
D. Single cycle mode - Lightly pull the trigger for a single cycle. Release the trigger and
cycle is complete.
E. Automatic mode - Pull trigger as far as possible to depress both valve stems. Release the trigger to stop.
Warning! With the secondary trigger device raised, the tool will cycle each time the trigger is pulled!
Warning! With the secondary trigger device raised, the tool will cycle at up to 30 times a second when the
trigger is pulled in automatic mode.
ALL MODELS ADDITIONAL WARNINGS:
Warning: The secondary trigger device should be checked periodically, to ensure it is operating correctly.
While following the above tool operation check notes, release the secondary safety trigger and the operating
trigger simultaneously, this should automatically lockout the operating trigger, preventing the tool from being
actuated.
The tool should only then operate again when the secondary trigger device is raised and the operating trigger is
depressed.
Warning: If the tool fails to work correctly contact you local STANLEY service centre or distributor for advice
before continuing to use it.
Warning: Under no circumstances should the secondary trigger device or the operating trigger be by-passed,
modified or removed.
Technical Data:
Please look for the following data in the table marked ? at the end of this manual.
A Length mm.
B Height mm.
C Width mm.
D Weight Kg.
E Noise L , 1s, d
PA
F Noise L
WA
G Noise L , 1s, 1m
PA
H Vibration m/s
I P max Bar
J P min Bar
, 1s, d
2
K Air consumption per shot @ 5.6 Bar
L Activation type
M Summer lubricant
N Winter lubricant
O O-ring lubricant
P Fastener Name
Q Dimensions mm.
R Head/crown
S Magazine capacity
T New Driver Length mm.
U Max. Depth Inside Piston mm.