First-time setup of your device
Mounting the feet (only device versions
with hand vein sensor)
Feet
Feet
Before initial startup of the above-mentioned device versions, Fujitsu recommends
that you mount the supplied feet.
► For how to install the feet, see section
Connecting the AC adapter
ACadapter
Makingreadytouse
Observe the safety notes in the enclosed "Safety/Regulations" manual.
The supplied AC cable conforms to the requirements of the country in which
you purchased your device. Make sure that the AC cable is approved for
use in the country in which you intend to use it.
3
1
20
"Using the palm vein sensor (device-dependent)", Page
► Connect the AC cable (1) to the AC adapter.
► Plug the AC cable (2) into a power outlet.
► Connect the AC adapter cable (3) to the
DC jack (DC IN) of the device.
2
71.
Fujitsu