Installation - Hotpoint H64IL9PAA S SK Operating Instructions Manual

Installation

! Please keep this instruction booklet in a safe place for
GB
future reference.. Make sure the booklet remains with the
appliance if it is sold, given away or moved.
! Please read this manual carefully: it contains important
information on installation, operation and safety.
! The appliance must be installed by a qualified
professional in accordance with the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the cooker has been disconnected from
the electricity supply.
Positioning and levelling
! The appliance may be installed alongside any
cupboards whose height does not exceed that of the
hob surface.
! Make sure that the wall which is in contact with the
back of the appliance is made from a non-flammable,
heat-resistant material (T 90°C).
To install the appliance correctly:
• Place it in the kitchen, the dining room or the studio
flat (not in the bathroom).
• If the top of the hob is higher than the cupboards, the
appliance must be installed at least 600 mm away from
them.
• If the cooker is installed underneath a wall cabinet, there
must be a minimum distance of 420 mm between this
cabinet and the top of the hob.
This distance should be increased to 700 mm if the wall
cabinets are flammable (see figure).
HOOD
600
Min. mm.
Levelling
*
Only available in certain models.
10
• Do not position blinds
behind the cooker or less
than 200 mm away from
its sides.
• Any hoods must be
installed in accordance
with the instructions listed
in the relevant operating
manual.
If it is necessary to level the
appliance, screw the adjustable
feet into the positions provided
on each corner of the base of the
cooker (see figure).
The legs* fit into the slots on the
underside of the base of the
cooker.
Electrical connection
Fitting the power supply cable
To install the cable, follow the instructions below:
• Loosen the cable clamp screw and the wire contact
screws
• To carry out the electrical connections as shown in
the figures, use the two jumpers inside the box (see
figure - labelled "P").
• Secure the power supply cable by fastening the cable
clamp screw then put the cover back on.
Electrical Connection
Those ovens equipped with a three-pole power supply
cable are designed to operate with an alternating current
with the voltage and frequency indicated on the data
plate (located on the appliance) and in the instruction
manual. The wire for earthing the appliance is yellow-
green in colour.
Connecting the supply cable to the electricity mains
Install a standardised plug corresponding to the load
indicated on the appliance data plate (see Technical
data table).
The appliance must be directly connected to the
400V 3N~
H05 RR-F5x1.5 CEI-UNEL 35363
400V 2N~
H05 RR-F4x2.5 CEI-UNEL 35363
230V ~
H05 RR-F 3x4 CEI-UNEL 35363
To open the terminal
board:
• Insert a screwdriver
into the side tabs of the
terminal board cover.
• Pull the cover to open
it.
N L1 L2 L3
Fig. A
N L1 L2
Fig. C
L
N
Fig. D