NEC pmn User Manual page 15

E - 8
4. For the LCD
video signal cable to the appropriate connector on the back of
the monitor.
For the LCD
connectors on the back of the monitor. Connect the red BNC
cable to the BNC connector on the monitor labelled R, the
green BNC cable to the BNC connector on the monitor
labelled G/Sync, the blue BNC cable to the BNC connector
on the monitor labelled B . If you have a fourth BNC
connector (Composite Sync), connect it to the BNC connector
on the monitor labelled H/CS. If you have a fifth BNC
connector (Vertical Sync), connect it to the BNC connector
on the monitor labelled VS.
Note: Incorrect cable connections may result in irregular operation,
damage display quality/components of LCD module and/or shorten the
module's life.
5. Connect one end of the power cable to the MultiSync LCD
monitor and the other end to the power outlet.
6. Turn on the monitor and the computer.
7. This completes the installation.
If you have any problems, please refer to the Troubleshooting section of
this manual.
Please contact your local dealer for information about the Mac Adapter.
Power Macintosh 6100/60 and 66 users need to use the Apple HDI-45
cable adapter and Powerbook users need to use the Apple VID-14 cable
adapter in conjunction with the appropriate MultiSync Macintosh cable
adapter when connecting a MultiSync LCD monitor.
: Connect the 15-pin mini D-SUB of the
400
: Connect the BNC cable to the appropriate
2000
Installation