Connections; Connect Antenna; Connect Vcr - NEC AccuSync PV32 User Manual

Additional equipment (VCRs, camcorders, etc.) can be connected to
the set. Check with your equipment manufacturer's instructions for
specific information. Unplug the set and all equipment before
connecting to avoid damage to the set or equipment.
Items shown may be different than actual equipment.

Connect Antenna

To connect an Antenna or Cable Service without a Cable Box
Connection.
For optimum picture quality, adjust antenna direction if needed.
Multi-family Dwellings / Apartments
(Connect to wall antenna socket)
wall antenna socket
VHF antenna
UHF antenna
outdoor antenna
Single-family Dwellings / Houses
(Connect to wall jack for outdoor antenna)

Connect VCR

Y Pb Pr
COMPONENT IN
ANT
VIDEO (L) AUDIO (R)
AV1 IN
ANT IN
S-VIDEO
ANT OUT
1
CH3
< Back panel of the set >
RF coaxial wire (75 ohms)
When in Video mode, the set will automatically revert to TV mode if the CH
or number buttons are pressed.
S-VIDEO IN RS-232
Connection 1
VIDEO (L) AUDIO (R)
AV2 IN Set VCR switch to 3 or 4 and then tune TV to the same channel number.
2
Connection 2
1. Connect the audio/video output jacks on VCR to the corresponding input jacks on the TV.
OUT
When connecting the TV to a VCR, match the jack colors (Video = yellow, Audio Left =
IN
CH4
(R) AUDIO (L) VIDEO
white, and Audio Right = red).
VCR
2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR
owner's manual.)
3. Use the INPUT button on the remote control to select AV1, AV2 or AV3. (If connected to
S-VIDEO on back panel, select the S-Video external input source.)
ANT
Internal Wire
Be careful not to bend the internal
wire when connecting the antenna.
English-11

Connections

ANT
D E button
/