Setting The Basic Functions; Volume - Sonoro iElements Instruction Manual

6. Setting the basic functions

6.1 Switching the device on
Touch the symbol on the front of the device. Your iElements is equipped with a touch
sensor at this point. That means that a light touch is sufficient. After it is switched on, the
most recently used music mode (FM radio, AM radio, iPod, Aux) is activated, the music slowly
fades in and the LED illuminated ring feature is activated.
NOTE!
You can deactivate the LED illuminated ring feature in the settings of your
iElements. Refer to section 8.6 for details. Your iElements can also switch on
automatically. Refer to section 8.2 for information on using the alarm function.
6.2 Switching the device off
Touch and hold on the front of the device about two seconds to switch off your device.
GOOD-BYE appears on the display, followed by the time, and the controls lighting is slowly
turned off.
NOTE!
Your iElements can also switch off automatically after a certain time. Refer to
section 8.3 for information on using the automatic switch-off feature.

6.3 Volume

When the device is switched on, you can increase the volume of your iElements with the +
button and lower it with the – button. The display shows the selected volume. You can set the
volume from VOL MIN (mute) to VOL MAX in 30 stages.
DANGER!
Never use your iElements at an excessively high volume level. If you listen to
the device at an excessively high volume for long periods of time, you endanger
your hearing. Also refer to the safety instructions in section 2.
16