Maintenance And Care - Hotpoint HNP 6.5 CM X/HA Operating Instructions Manual

Models with soft button keypad and display
HNP 6.5S CD X/HA
HPS 60 IX/HA
T1 T2 T3
1 Motor ON/OFF
Press the button with the hood off to set speed 1. Pressing
the button while the hood is in operation turns it OFF.
T2 Speed -
Pressing the button returns the hood to the previous speed.
T3 Speed +
Pressing the button returns the hood to the next speed
T4 Booster
Pressing this button sets the hood to high speed; the letter
"b" flashes slowly on the display. After 5 minutes, the hood
returns to its previous speed; this can also be done while
booster mode is on by pressing either speed button (T2
or T3).
T5 Timer
Pressing this button delays the hood turning off automatically
by 5 minutes. The timer counts down on the display in
minutes. The timer can only be set for manual speeds, not
for booster mode.
T6 Lights ON/OFF
Grease/odour filter warnings
The bar at the top left flashes to indicate
that the grease filter is saturated.
The bar at the top right flashes to indicate
that the odour filter is saturated.
If both bars are flashing, then both filters
are saturated.
You must then clean/replace the grease filter (A) or odour
filter (B) or both, accordingly (see "Maintenance and care").
The latter only applies to the filter version.
B
T4 T5 T6
To reset the filter counter:
Hold down T4 for three seconds while the hood is on.
If both filter warnings are active at the same time, you must
reset each separately.
The first sequence resets the grease filter, while the second
sequence resets the odour filter.
Confi guring the hood
To set the operating mode of the hood, hold down T4 for 6
seconds while the product is off. After a long beep, the type
of installation displays:
Ducted
(square at bottom left flashing).
Filter
(square at bottom right flashing).
You can change the type of installation by pressing T4. To
quit configuration mode, press T1 once; this switches the
unit off and saves the last displayed setting.

Maintenance and care

Caution! Before cleaning or servicing the unit,
disconnect it from the mains by pulling the power plug
or disconnecting the main circuit breaker.
First cleaning
• Remove the protective film
• Clean with a damp sponge and a little neutral soap
• Rinse off with a damp cloth
• Dry with a soft cloth; if the hood is stainless steel, dry
along the metal's grain
Periodic cleaning
The hood must be cleaned frequently (at least as often as
you service the grease filter), inside and out. Use a damp
cloth and a neutral liquid detergent with lukewarm water.
Do not use abrasive or corrosive products.
Warning: Failure to observe the hood cleaning and filter
cleaning/replacement instructions can result in fires. Follow
the instructions carefully. The manufacturer is not liable for
any damage to the motor or fires caused by incorrect care
or failure to follow the above instructions.
GB
37