Table of Contents
Advertisement
IMPORTANT
With unit positioned at installation site, remove two side
Iouvered panels to expose the unit base pan. Install the
brackets as illustrated
in figure 6 using conventional
practices; replace the panels after installation is complete.
Slab Side Mounting
ONE BRACKET
PER SIDE (MIN.); FOR EXTRA
STABILITY,
2 BRACKETS
PER SIDE, 2" FROM EACH CORNER.
Figure 6. Installing
Stabilizer Brackets
ROOF MOUNTING
Install unit 6" (152 mm) above the roof surface to avoid ice
build-up around the unit. Locate the unit above a load
bearing wall or area of the roof that can adequately support
the unit, Consult local codes for rooftop applications.
If unit cannot be located away from prevailing winter winds,
construct a wind barrier sized at least the same height and
width as outdoor unit, Position barrier 24" (610 mm) from
the sides of the unit in direction of prevailing winds as
illustrated in figure 7,
inlet a[_
prevailing winter winds
wind barrier
]
24"
inlet air ,_
_641'0 ram)
O
inlet air
inlet air
Figure 7. Rooftop Application
with Wind Barrier
If unit cannot be located away from prevailing winter winds,
construct a wind barrier sized at least the same height and
width as outdoor unit. Position barrier 24" (610 mm) from
the sides of the unit in direction of prevailing winds (fig. 7).
IMPORTANT! Do not allow panels to hang on unit by top tab.
Tab is for alignment and not designed to support weight of panel,
Panel shown slightly rotated to allow top tab to exit (or enter) top
slot for removing (or installing) panel.
LIP
SCREW
HOLES
Detail
J
ROTATE IN THIS
DIRECTION;
THEN DOWN
TO REMOVE
PANEL
Figure 8. Removing/Installing
Louvered
Panels (Details A, B and C)
Remove the Iouvered panels as follows:
1, Remove 2 screws, allowing the panel to swing open
slightly (see figure 8).
2. Hold the panel firmly
throughout
this procedure.
Rotate bottom corner of panel away from hinge corner
post until lower 3 tabs clear the slots (see figure 8,
Detail B),
Page 5
HP13
SERIES
Advertisement
Table of Contents
