Lennox HP13 Series Installation Instructions Manual page 6

UTDOOR
FAN
PURPLE
BLACK
ORANGE
RED
START
CAPACITOR
DUAL
CAPACITOR
DEFROST CONTROL
,j! o +
LLOW
COMPRESSOR
CRANKCASE
HEATER
BLACK
POTENTIAL _M_SOR (_
CONTACTOR
I / I
DEFROST.ff'"x _'\,REVERSING
THERMOSTAT_ _VALVE
o_- ©
Y1ou_
*MAY BE OPTIONAL
--C
--L
--R
--0
--YI
/k
20B-230/60/I
EQUIPMENT
GROUND
T
Figure 9. Typical Field Wiring Diagram
3. Move panel down until lip of upper tab clears the top MAINTAIN MINIMUM PANEL ANGLE
(AS
CLOSE TO PARALLEL WITH T HE UNIT
slot in corner post (see figure 8, Detail A).
AS POSSIBLE)
WHILE INSTALLING PANEL.
HOLD DOOR FIRMLY TO THE HINGED
ANGLE MAY BE TOO SIDE TO MAINTAIN
EXTREME _-_ FULLY-ENGAGED TABS
CAUTION
PREFERRED ANGLE
Detail D
Position and Install Panel--Position the panel almost
parallel with the unit (figure 8, Detail D) with the "screw
side" as close to the unit as possible, Then, in a continuous
motion:
• Slightly rotate and guide the lip of top tab inward (figure
8, Details A and C); then upward into the top slot of the
hinge corner post,
• Rotate panel to vertical to fully engage all tabs,
• Holding the panel's hinged side firmly in place, close
the right-hand side of the panel, aligning the screw
holes.
When panel is correctly positioned and aligned, insert the
screws and tighten,
Figure 10. Removing/Installing Louvered
Panels (Detail D)
In the U.S.A., wiring must conform with current local codes
and the current National Electric Code (NEC). In Canada,
wiring must conform with current local codes and the current
Canadian Electrical Code (CEC).
Refer to the furnace or blower coil installation instructions
for additional wiring application diagrams and refer to unit
nameplate for minimum circuit ampacity and maximum
overcurrent protection size.
505076M 06/07
Page 6