Configuration Via The Dynamic Select Switch - Mercedes-Benz Comand Operating Instructions Manual

If the climate control is switched off:
the climate control setting functions are
R
deactivated.
the blower is switched off.
R
the air recirculation flaps are closed.
R
Switching cooling with air dehumidifi-
cation on/off
This setting is made in the bottom bar of the
climate control menu.
Call up the climate control menu (
X
Slide 6 the controller repeatedly until the
X
bottom bar is activated.
To select O A/C: turn and press the control-
X
ler.
Switch cooling with air dehumidification on
X
O or off ª.
i
The current status of the cooling function is
displayed in the climate control bar: A/C ON
– activated, A/C OFF – deactivated
( page 49).
Y
i
Deactivating the cooling with air dehumidi-
fication function reduces fuel consumption.
Synchronizing the climate control set-
tings
Use O Sync (synchronization) to select the cli-
mate control setting for all zones together O or
separately ª.
This setting is made in the bottom bar of the
climate control menu.
Call up the climate control menu (
X
Slide 6 the controller repeatedly until the
X
bottom bar is activated.
To select O Sync: turn and press the con-
X
troller.
Switch the synchronization function on O or
X
off ª.
For further information on synchronizing climate
control settings (see the vehicle Operator's
Manual).
DYNAMIC SELECT
General notes
You can use
following settings for the Individual drive pro-
gram:
Drive system
R
Suspension
R
Steering
R
Climate control
R
ECO start/stop function
R
page 50).
Y
In addition, current vehicle and engine data is
visualized via the two further
Engine Data
i
In a few countries, the ECO start/stop func-
tion is deactivated at the factory due to the
available fuel grade. In this case, the ECO
start/stop function is not available regardless
of the display in the multimedia display.
The ECO Assist setting is available on PLUG-IN
HYBRID vehicles.
In Mercedes-AMG vehicles, you can use
DYNAMIC SELECT
tings for the Individual drive program:
Drive system
R
Suspension
R
Transmission
R
Sports exhaust system
R
Electronic Stability Program ESP
R
There may be fewer settings or none depending
on your vehicle's equipment.
For further information on the Individual drive
program; see the vehicle Operator's Manual.
page 50).
Y
Configuration via the DYNAMIC
SELECT switch
Use the DYNAMIC SELECT switch to select
X
the Individual drive program; see the vehicle
Operator's Manual.
A window appears after a short while.
To confirm Adjust: press the controller.
X
The Individual Configuration
setting the drive program appears.
DYNAMIC SELECT
DYNAMIC SELECT to configure the
Vehicle Data
menus.
to configure the following set-
®
51
and
menu for
Z