Sharp FP-FM40E Operation Manual page 11

MOSQUITO CATCHER
Use this function to be worried about mosquito.
1)
2)
3)
NOTE
Select Max mode to catch mosquito more effectively.
The higher the air volume, the easier to capture a mosquito.
1) CATCH lamp
When UV LIGHT lamp is on and GLUE SHEET lamp is on, CATCH lamp is on.
When UV LIGHT lamp is off or GLUE SHEET lamp is fl ashing, CATCH lamp is off.
2) UV LIGHT lamp
When Mosquito Catcher button is pressed, UV LIGHT lamp is turned on and conversely.
UV LIGHT
off
UV LIGHT ●
fl ashing
3) GLUE SHEET lamp
fl ashing
• Flashing Glue Sheet lamp indicates time to change Glue Sheet.
Glue Sheet comes in 3 layers with each layer laminated. Change the Glue Sheet by peel off
the used one. When all layers have been used, replace with a new sheet.
Press the Mosquito Catcher button 3 seconds.
Glue Sheet lamp change from fl ashing to lighting.
• This Glue Sheet lamp is flashing after approx. 1 month (24hours x 30 days) after pushing
Mosquito Catcher button 3 seconds.
• At the fi rst time of using it after inserting a plug in a socket and turning on the power, Glue Sheet
lamp will be fl ashing by default. Install Glue Sheet to catch panel (see page E-7), then press the
Mosquito Catcher button 3 seconds.
• The mosquitoes which have not got caught in Glue Sheet might escape from the window of
Catch Panel, so please do not switch off the power while Mosquito Catcher is in operation as
much as possible except for exchanging fi lter and Glue Sheet.
OM_FP-FM40E_40L_EN.indd Sec1:9 OM_FP-FM40E_40L_EN.indd Sec1:9
UV Light ON
If Catch Panel comes off, UV light is turned off automatically by Magnet
sensor. Check whether catch panel is properly attached.
When UV LIGHT lamp is flashing, UV Light has failed. Contact the
service center authorized by Sharp.
more than 3 sec.
E-9
UV Light OFF
7/24/2558 BE 9:02 AM 7/24/2558 BE 9:02 AM