Sound Bar Setup - NEC MultiSync LCD1770V User Manual

Sound bar Setup

To attach the Sound bar to your LCD1770NXM, follow these instructions. Note:
this setup is only for the LCD1770NXM. If you have purchase an LCD1770V or
LCD1770NX, please move to the next page.
1. Turn off the computer.
2. Place hands on each side of the display to tilt up the panel and then lift up to the
highest position.
3. Use the two thumb screws included to attach the Sound bar to the display (Figure SB.1).
4. Turn the volume control down on the Soundbar (Figure SB.2).
5. Connect the light blue color audio cable plug to the light blue jack of Sound bar (Figure
SB.1). Connect the other end of the audio cable into the back of your computer.
NOTE: Headphones may be connected to the headphones jack on the right side of the
Sound bar (Figure SB.2). Headphones can be purchased from your local electronics
store.
6. Connect the DC power cable of Sound bar to DC-OUT terminal of display (Figure SB.1).
7. You are now ready to move to the next step in setting up your MultiSync LCD.
Figure SB.1
Figure SB.2
LCD17PISAManual080604.p65
DC-OUT Terminal
of Display
Thumb
Screw
Audio
Cable
Headphone Jack
VOL.
VOL.
Volume Control
3
3
Thumb
Screw
DC Power
Cable
8/6/04, 5:14 PM