Advertisement
Quick Links
Model:
1700W Solar Battery Charger
MPPT30-1
Maximum Power Point Tracker
Page 1 of 8
Operating Instructions
Please read these instructions before use
This revolutionary maximum power point tracker solar charger was
designed using the technology that won GSL Electronics the prestigious
"2008 EDN Innovation award". A simple, compact and low cost
alternative. Ideal for charging batteries with the new low cost and high
efficiency grid type panels.
MPPT30-1 Unit
PATENT APPLIED FOR - 2010901565
MPPT30-1-R7
Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for GSL MPPT30-1
Summary of Contents for GSL MPPT30-1
- Page 1 Please read these instructions before use This revolutionary maximum power point tracker solar charger was designed using the technology that won GSL Electronics the prestigious “2008 EDN Innovation award”. A simple, compact and low cost alternative. Ideal for charging batteries with the new low cost and high efficiency grid type panels.
- Page 2 1700W Solar Battery Charger MPPT30-1 Maximum Power Point Tracker Page 2 of 8 Operating Instructions Please read these instructions before use MPPT30-1 Specifications Efficiency typical Input voltage 16V to 95V Float 13.5V / 27V / 54V Output voltage Absorption – Vented LA batteries 14.5V / 29V / 58V –...
- Page 3 Page 3 of 8 Operating Instructions Please read these instructions before use The MPPT30-1 is designed to charge sealed and vented lead acid batteries from photovoltaic pannels. Silicon based panels such as monocrystalline, polycrystalline and amorphous are suitable. MPPT30-1 General Information: •...
-
Page 4: Important Notes
• This equipment must be installed by qualified personnel only and incorrect wiring can cause fire, injury or death – GSL will accept no responsibility for MPPT misconnection or misuse. • Use only sealed or vented 12V, 24V or 48V lead acid batteries and confirm the MPPT settings, charge voltages and currents are correct for your battery system –... - Page 5 Model: 1700W Solar Battery Charger MPPT30-1 Maximum Power Point Tracker Page 5 of 8 Operating Instructions Please read these instructions before use Changing Battery Type Setting Procedure 1.Ensure all the MPPT wires are disconnected. Disconnecting PV first. 2.Remove the 5 front panel screws and the move the front panel ajar. Then remove 1 middle rear screw on the back panel (bottom middle below fan) then slide out bottom cover –...
- Page 6 Model: 1700W Solar Battery Charger MPPT30-1 Maximum Power Point Tracker Page 6 of 8 Operating Instructions Please read these instructions before use Figure 2 (Above): Vented Battery Setting Figure 3 (Above): Sealed Battery Setting MPPT30-1-R7 Unit 2, 110 Station Road, Seven Hills ,NSW, 2147, Australia...
- Page 7 GSL Electronics (GSL) warrants that its products will, under normal use and service, be free of defects in material and workmanship for a period of two (2) years from the date of the original purchase by the customer as marked on the customer’s original invoice. Please refer to our website for full warranty and return information which can be found at http://www.gsl.com.au/faq.html...
- Page 8 Model: 1700W Solar Battery Charger MPPT30-1 Maximum Power Point Tracker Page 8 of 8 Operating Instructions Please read these instructions before use For optimal performance from panel and MPPT please use the following table to determine the best setup for your situation.
Need help?
Do you have a question about the MPPT30-1 and is the answer not in the manual?
Questions and answers