Resetting To The Factory Default Settings; Accessing The Camera From The Internet; Further Information - Axis P3344-VE Installation Manual

Page 22

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the factory default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power (see "Hardware overview" on page 6).
3. Keep the Control button pressed for about 15 seconds until the Status indicator displays amber.
4. Release the Control button. The process is complete after about 1 minute (when the Status
indicator turns green). The network camera has been reset to the factory default settings. The
default IP address is 192.168.0.90
5. Re-assign the IP address.
6. Refocus the camera.
It is also possible to reset parameters to factory default via the web interface. Go to Setup > System
Options > Maintenance.

Accessing the camera from the Internet

Once installed, your AXIS P3343-VE/P3344-VE/P3346-VE/P3367-VE is accessible on your local
network (LAN). To access the camera from the Internet, network routers must be configured to
allow incoming traffic, which is usually done on a specific port
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for viewing H.264 video streams
Please refer to the documentation for your router for further instructions. For more information on
this and other topics, visit the Axis Support Web at www.axis.com/techsup

Further information

The user's manual is available from the Axis Web site at www.axis.com or from the Axis Network
Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your Axis product.
To see the currently installed firmware version, see Setup > About in your web interface.
AXIS P33-VE Series Network Camera Installation Guide