Advertisement
3 3 3 3 - - - - 2. 2. 2. 2. Configuring AP
Configuring AP with
Configuring AP
Configuring AP
Alternatively, the AP can be configured via console and serial port on your PC.
1.Connect power supply to PoE injector with the AC power cord provided, and connect The AP to
POWER & DATA OUT port on the PoE with MIL-C-5015 IP67 Cat-5 Ethernet Cable provided as
POWER & DATA OUT
POWER & DATA OUT
POWER & DATA OUT
shown in the connection diagram. Both POWER
is properly powered-on.
2.Connect the AP and the PC with MIL-C-5015 IP67 RS-232 Console Cable with 115200bps
connector (the black color RS232 connector) provided.
3.Adjust the baud rate of your terminal software to 115200bps (128kbps).
4.Set the flow control to N/A.
5.Connect the AP from terminal software.
6.Enter the default password
If the connection is correct, the main menu of The system menu tree (SMT) will appear on your
terminal software.
( ( ( ( Note:
Note: The Web UI is ID: admin / PW: password
Note:
Note:
4. 4. 4. 4. Outdoor Installation
Outdoor Installation
Outdoor Installation
Outdoor Installation
Mounting Kits
with C C C C onsole
with
with
onsole
onsole
onsole
POWER and ACTIVE
POWER
POWER
"0000
0000" and press enter on your keyboard to into the main menu of SMT.
0000
0000
The Web UI is ID: admin / PW: password. . . . ) ) ) )
The Web UI is ID: admin / PW: password
The Web UI is ID: admin / PW: password
ACTIVE LED on the PoE will be on when The AP
ACTIVE
ACTIVE
4
V1.0
Advertisement
