Power Led - Lindy 38200 User Manual

User Manual
Receiver – Front & Back Panels
RS 232 OUT
RS-232 OUT
1.
Connect to a device which is controlled by RS-232 commands using a 9 Way D cable.
IR IN 1
2.
Connect the supplied IR Extender cable for IR signal reception. Ensure that remote being used is
within the direct line-of-sight of the IR Extender.
IR OUT 2
3.
Connect the supplied IR Blaster Cable for IR signal transmission. Place the IR Blaster in direct line-
of-sight of the equipment to be controlled.
LAN
4.
Connect to an internet or network connection – never connect to an HDBaseT port.
CAT5e/6/7 IN
5.
Connect to the CAT5e/6/7 OUT port on the Transmitter unit with a single CAT5e/6/7 cable for
transmission of all data signals – never connect to a network port. The yellow LED will illuminate to
represent the link from Transmitter is stable, if it blinks irregularly it represents a link error or when
not illuminated it means no link with the Transmitter. The green LED will illuminate to represent the
HDMI signal contains HDCP.

Power LED

6.
The LED will illuminate when power is received via PoE from the Transmitter
HDMI OUT
1.
Connect to HDMI display equipment such as a TV or projector.
USB
2.
Connect to USB peripheral equipment for use with the PC/Laptop connected to the Transmitter.
POWER LED
3.
Illuminates to show power is available via USB.
LINK 1 & 2
4.
Illuminates to show a USB peripheral is connected with an active signal.
COAX OUT 1
5.
Connect to speakers with a coaxial input to receive audio from COAX IN 1 located on the Receiver.
COAX IN 2
6.
Connect to an audio source such as an AV Amplifier, audio is sent to the Receiver's COAX OUT2.
Audio OUT L/R
7.
Connect to speakers with an RCA input, audio is received from the Transmitter's AUDIO IN L/R.
IR IN 1 IR OUT 2
1 2
LAN CAT5e/6/7 IN
3 4
POWER
5 6
English