Backbone Source - NEC MA4000 User Manual

MA4000 Expense Management Cable Management User Guide - Issue 1

Backbone Source

Setting up the backbone source
Click the Source tab. The Connection Location box is populated with the
Step 1
selected source location.
In the Connection Device Type box, click the appropriate radio button:
Step 2
—Termination Hardware if this backbone starts on termination
hardware.
—Splice Enclosure if the backbone starts at a splice.
—Asset if the backbone starts at an asset.
Click Save.
Step 3
Backbone Source
Click the Source tab. The Connection Location Select group box is
Step 1
populated with the selected source location.
The Connection Device Type frame contains radio buttons labeled
Step 2
Termination Hardware, Splice Enclosure, or Asset.
Click the Termination Hardware button if this backbone starts on
Step 3
termination hardware.
Click the Splice Enclosure button if the backbone starts at a splice.
Step 4
Backbone Destination
The Destination tab functions similarly to the Source tab, except that
the Connection Location Select information is not populated.
Setting up the backbone destination
Click the Set Location button in the Detail area to open the Location
Step 1
window.
Select the Destination from the tree. Building, Floor, and Space are
Step 2
populated, unless you are connecting from an outdoor space, such as a
Utility Pole. In that case, only Space is populated.
Click Accept.
Step 3
In the Connection Device Type box, click the appropriate radio button:
Step 4
—Termination Hardware if this backbone ends on termination
hardware.
—Splice Enclosure if the backbone ends at a splice.
—Asset if the backbone ends at an asset.
Click Save.
Step 5
Setting Up Infrastructures 4-21