Touch Control Panel - Hotpoint Ariston AQUALTIS AQM8D 49 U Instructions For Installation And Use Manual

Touch control panel

WASH CYCLE
SELECTOR
knob
ON/OFF
Button with
indicator light
Button with ON/OFF indicator light: press this briefly
to switch the machine on or off. The green indicator light
indicates that the machine is switched on. To switch off
the washer-dryer during the wash cycle, press and hold
the button for approximately 3 seconds; if the button is
pressed briefly or accidentally the machine will not switch
off. If the machine is switched off during a wash cycle, this
wash cycle will be cancelled.
WASH CYCLE SELECTOR knob: may be turned in
either direction. To select the most suitable wash cycle,
please refer to the "Table of wash cycles".
The knob will not move during the wash cycle.
M1-M2 buttons: press and hold one of the buttons to
store a cycle with your own set preferences in the memory
of the machine. To recall a previously-stored cycle, press
the corresponding button.
DRYING button : press to decrease or exclude drying;
the selected drying level or time will appear on the display
(see "How to run a wash cycle or a drying cycle").
button: press to modify or exclude
TEMPERATURE
the temperature setting; the value selected will appear
on the display above (see "How to run a wash cycle or a
drying cycle").
SPIN CYCLE button: press to modify or exclude the
spin cycle; the value selected will appear on the display
above (see "How to run a wash cycle or a drying cycle").
DELAYED START button: press to set a delayed start
for the selected wash cycle; the set delay time will appear
on the display above (see "How to run a wash cycle or a
drying cycle").
OPTION buttons: press to select the available options.
The indicator light corresponding to the selected option will
remain lit (see "How to run a wash cycle or a drying cycle").
M1
M2
DISPLAY
OPTION
DRYING
buttons
SPIN
button
ECO
TEMPERATURE
indicator light
button
DELAYED START
button
DOOR LOCKED
WASH CYCLE PHASE icons: these illuminate to indicate
the progress of the wash cycle (Wash
Spin/Drain – Drying
cycle is complete.
START/PAUSE button with indicator light: when the green
indicator light flashes slowly, press the button to start a
wash cycle. Once the cycle has begun the indicator light
will remain lit in a fixed manner. To pause the wash cycle,
press the button again; the indicator light will flash in an
orange colour. If the "Door locked"
switched off, the door may be opened. To start the wash
cycle from the point at which it was interrupted, press the
button again.
DOOR LOCKED indicator light: indicates that the
porthole door is locked. To open the door, pause the wash
cycle (see "How to run a wash cycle or a drying cycle").
CONTROL PANEL LOCK
to activate or deactivate the control panel lock, press and
hold the button for approximately 2 seconds. when the
indicator light is illuminated, the control panel is locked.
This means it is possible to prevent wash cycles from being
modified accidentally, especially where there are children in
the home.
ECO indicator light: the
altering the washing parameters, an energy saving of
at least 10% is made. Furthermore, before the machine
enters "Standby" mode, the icon will light up for a few
seconds; when the machine is switched off the estimated
energy saving will be around the 80% mark.
START/PAUSE
button
with indicator light
WASH
CYCLE
PHASE
icons
CONTROL PANEL
LOCK
button with
indicator light
indicator light
– Rinse –
). The text lights up when the
indicator light is
button with indicator light:
icon lights up when, after
EN
5