Description Of The Machine - Hotpoint Ariston AQUALTIS AQM8D 49 U Instructions For Installation And Use Manual

Description of the machine

EN
PORTHOLE DOOR
PORTHOLE DOOR
HANDLE
KICK STRIP
PORTHOLE DOOR
DETERGENT DISPENSER DRAWER
3
1
2
recommend it is poured into the drawer immediately before
you start the washer-dryer.
3. extra compartment: Bleach
4
ADJUSTABLE FEET
Always use the handle to
open the porthole door (see
figure).
The detergent dispenser
drawer is located inside
the machine and can be
accessed by opening the
door.
For more information on
detergent measures, please
refer to the chapter entitled
"Detergents and laundry".
1. pre-wash compartment:
use powder detergent.
! Before pouring in the
detergent, make sure that
extra compartment 3 has
been removed.
2. main wash compartment:
use powder or liquid
detergent. If using the
latter type of detergent, we
CONTROL
PANEL
! The use of extra compartment 3 excludes the pre-
wash function.
washing additives compartment: for fabric softener
or liquid additives. We recommend that the maximum
level indicated by the grille is not exceeded, and that
concentrated fabric softeners are diluted.
TOUCH CONTROL PANEL
Standby mode
This washer-dryer, in compliance with new energy saving
regulations, is fitted with an automatic standby system
which is enabled after about 30 minutes if no activity is
detected. Press the ON-OFF
the machine to start up again.
CHANGE LANGUAGE
The first time the machine is switched on, the first language
will flash on the display. The " ", "OK" and "V" symbols will
appear on the display, in line with the 3 buttons on the right-
hand side. The languages change automatically every 3";
alternatively, they can be changed by pressing the buttons
next to the " " and "V" symbols. Use the "OK" button to
confirm the language, which will be set after 2". If no buttons
are pressed, the automatic language change will begin again
after 30".
The language may only be changed while the machine is
switched off.
Press and hold the temperature
buttons for 5''; a short beep sounds and the set language
flashes on the display. Press the buttons next to the " " and
"V" symbols to change the language. Use the button next to
the "OK" symbol to confirm the language, which will be set
after 2". If no buttons are pressed, the language set previously
will be displayed after 30". Switch on the machine.
To adjust the settings, gently
press the icon inside the
sensitive (touch control) area
as illustrated in the figure.
button briefly and wait for
+spin +delayed start