Model Setting - Pioneer BDP-05FD Service Manual

1

8.2 MODEL SETTING

QQ
3 7 63 1515 0
Destination Setting Screen
A
B
• The screen for setting the destination region will be analogous to the screen shown in Fig. 1.
• A proportional font will be used.
• Entering a 4-digit number is possible with the remote control unit for service (Fig. 2).
• To shift to the next page, the SIDE-B key is used. When this key is pressed while the last page is displayed,
Page 1 will be displayed.
• To shift to the previous page, the SIDE-A key is used. When this key is pressed while Page 1 is being displayed,
the last page will be displayed.
The input numbers and model names will be changed when pages are changed (Fig. 3).
C
Other indications and operations are common to all pages.
• If there are several pages, any destination number will be accepted regardless of the currently displayed page.
• To exit the Destination Setting screen, press the ESC key.
TE
L 13942296513
• On input keys
Key
Keys 0-9 on the remote control unit for service
CLEAR key on the remote control unit for service
Keys other than those mentioned above will not be accepted.
• Once all 4 digits are input, that number is set.
D
-> If a number corresponding to the input number does not exist, the error message will be displayed. (Fig. 4)
-> After the error message is displayed, no key input will be accepted. (Unplug the power cord.)
• The first input numeric is displayed at the rightmost position then will be shifted to the left with subsequent key inputs,
as shown below:
No input
A "1" is input. (Even if a nonvalid numeric is input, the error message will not be displayed at this stage.)
A "2" is input. (Even if a nonvalid numeric is input, the error message will not be displayed at this stage.)
When the CLEAR key is pressed, the screen will return to the initial display.
E
A "3" is input. (Even if a nonvalid numeric is input, the error message will not be displayed at this stage.)
When the CLEAR key is pressed, the screen will return to the initial display.
A "4" is input. (If the input 4-digit number is not a valid number, "> 1234" is instantly [0.2 sec] displayed.
Then an error message will be displayed.)
When the CLEAR key is pressed, the screen will return to the initial display.
www
The above "> 1234" is instantly (0.2 sec) displayed
then the Model Setting screen will be cleared.
F • To correct the input data, press the CLEAR key on the remote control unit for service.
All the input numerics will be cleared.
52
1
http://www.xiaoyu163.com
2
Fig. 1: Screen image 1
For inputting numerics.
For canceling input numerics and returning to the initial display.
x ao
y
. i
2
http://www.xiaoyu163.com
3
8
Q Q
3 6 7 1 3
Operation
u163
.
BDP-05FD
3
4
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
4
9 9
2 8 9 9