Advertisement
3
Close the battery compartment lid and
secure it with the screw (see Fig.
@),
4
Press
iPod & iPhone HI, RADIO
BAND, AUDIO IN
or
SNOOZE/DATE/
SLEEP OFF
to turn
"co"
off in the
display.
Note
When you replace the battery, do not disconnect
the plug from the AC outlet. Otherwise, the
calendar. current time, alarm and station presets
will be initialized.
If the time in the display is
incorrect after the battery is
changed (Reset)
Press the reset button with a pointed device. The
reset button is in the small hole located in the
battery compartment (see Fig,
0),
®
®
To keep accurate time, this unit contains a
CR2032 battery as a backup power source.
The battery keeps the clock and the alarm
operating in the event of a power interruption.
Tip
Adjust the direction of the AM loop antenna for
best AM broadcast sound.
Pull the AM antenna terminal while pushing up
the terminal clamp.
Replacing the battery
1
Keep the AC plug connected to the AC
outlet, remove the
screw that secures the
battery compartment lid at the bottom of
the unit using a screwdriver, and open
the lid (see Fig.
CD).
2
Insert a new battery in the battery
compartment with the
0
side facing up
(see Fig.
®).
Adjusting the AM loop antenna
Find a place and an orientation that provide good
reception.
• Do not place the AM loop antenna near the
unit or other AV equipment, as noise may
result.
Notes
• Do not attempt to charge the battery.
• If you are not going to use the remote
commander for a long time, remove the battery
to avoid any damage that may be caused by
leakage and corrosion.
Knowing when to replace the
battery
When the battery becomes weak, "6\J" appears in
the display.
If a power interruption occurs while the battery is
weak, the current time and alarm
will
be
initialized.
Replace the battery with a Sony CR2032 lithium
battery. Use of another battery may cause a fire or
explosion.
Note
If"AM 12:00" flashes in the display when the unit
is connected to an AC outlet for the first time, the
battery may be weak. In this case, consult your
Sony dealer.
CR202S
~
Before using the card remote commander for the
first time, remove the insulation film.
About the backup
battery
Preparing the remote
commander
When to replace the battery
With normal use, the battery (CR2025) should
last for about six months. When the remote
commander no longer operates the unit. replace
the battery with a new one.
~~
~
To remove the AM loop
antenna
Channel step
Frequency
530 - 1 710 kHz
10 kHz
AM
Band
General
Speaker
Approx. 5.7 em (2
1/ 4
inches) dia. 6
n
Input
AUDIO IN jack
(0
35 mm stereo minijack)
Power output
3.5 W
+
3.5 W (at 10% harmonic distortion)
Power requirements
120 V AC, 60 Hz
For clock back up; 3V DC, CR2032 battery (I)
Dimensions
Approx. 2905 x 152.0 x 1395 mm (w/h/d)
(11
3 /
8
x
5
15/ 16 X
5
1/ 2
inches) including projecting
parts and controls
Mass
Approx. 1.94 kg (4 Ib 4 oz) including power
supply unit
Supplied accessories
Remote commander (1)
AM loop antenna (1)
Audio connecting cable (1)
Universal dock adapter for iPhone (1)
Universal dock adapter for iPhone 3G (I)
Design and specifications are subject to change
without notice.
Connecting the
antenna
3
Insert the AM antenna terminal into the
AM ANTENNA
jack on the rear of the
unit.
When Daylight Saving Time (summer time)
begins. the clock does not employ the
Daylight Saving Time automatically.
• Make sure the clock is set correctly.
• Press and hold
CLOCK
and
SNOOZE/DATE!
SLEEP OFF
simultaneously for at least
2 seconds to activate the Automatic DST
function.
FM
875 - 108 MHz
0,1 MHz
To connect the AM loop
antenna
The shape and the length of the antenna is
designed to receive AM signals. Do not dismantle
or roll up the antenna.
1
Remove only the loop part from the
plastic stand.
2
Set up the AM loop antenna,
§-.~
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6 ohm loads both channels driven, from
150 -10,000 Hz; rated 3 watts per channel
minimum RMS power, with no more than 10
%
total harmonic distortion.
Time display
12-hour system
iPod section
DC out: 5V
MAX:500mA
Radio section
Frequency range
(---I
iF'11
r--··...-.,
'1-----'
P~li
1,"::-,1
II
Ii
I
_--' I
II
II
6)JJ
I@I
II
II
L_...
:::J
!
L
'
iPod nano
1~~6
J
4th generation
iPoo
touch
(video)
iPhone 3G
2nd generation
FC=l'
~~
i ! ...
t .11
i~1
IL-~
..
JI
l~;)j
L@J
iPod nano 3rd
generation (video)
iPod touch
iPoddassic
rr
TI
rFiooli
..... !,
11_~JI
-'I
'Wi
l~cvl
[OJ
I -__
...J
iPod nano 2nd
generation
iPodSth
iPhone
(aluminum)
generation (video)
rroFn
r;=-==1'
rr-::;)
1~'''''J
I
L"'~ J I
dil
j
--I
10
1
!O!
101
!
I
l----.J
iPod
nano lst
L_.
.....!
L __
J
generation
iPod 4th generation
iPod4th
(color display)
g~n~ration
Compatible iPod models are as follows. Update
your iPod to use the latest software before you use
it.
Should any problem persist after you have made
the following checks, consult your nearest Sony
dealer.
Notes
• In these Operating Instructions, "iPod" is used
as a general reference to iPod functions on an
iPod or iPhone, unless otherwise specified by
the text or illustrations.
• The connector of the unit is for sole use with an
iPod. If you use devices that do not match with
the connector, connect to the AUDIO IN
terminal of this unit with the supplied audio
connecting cable.
• Sony cannot accept responsibility in the event
that data recorded to an iPod is lost or damaged
when using an iPod connected to this unit.
n==Yl
l
,
I
~--~
:
I
~'-~'
iPodmini
The clock flashes "AM 12:00" due to a power
interruption.
• The battery is low. Replace the battery. Remove
the old battery and install a new one.
The radio. IPod or buzzer alarm does not
sound at the preset alarm time.
• Check that alarm ''1\' or alarm "B" is properly
displayed,
The radio or IPod alarm is activated but no
sound comes on at the preset alarm time.
• Check the alarm volume setting.
There Is no sound from the IPod.
• Make sure the iPod is securely connected.
• Adjust the
VOLUME,
The IPod cannot be operated with this unit.
• Make sure the iPod is securely connected.
Troubleshooting
The IPod cannot be charged.
• Make sure the iPod is securely connected.
Features
• Clock Radio with iPod/iPhone 3G compatible
• Wake or Sleep to iPod/Radio/Buzzer
• Easy to set A-B alarm
• 2-5-7dayalarm
• LCD Brightness control
• MEGA BASS
• MEGAXpand
• Wireless Remote Commander
Compatible iPod
models
Advertisement
