Disposal Of Long Storage - Midland GP2660HC User Manual

with steel brush, the suitable clearance of sparking plug is 0.6 0.7mm.
Gear case
Every twenty working hours, use grease pump to add grease to the gear case
from the inlet.
Blade
Every 1 2 hours, add grease to the blade.
Mend the blade
1. Start the engine, allow the blade to run at low
speed, stagger the up and down blade for
2mm, and stop the engine.
2. After fixing the unit, sharpen the cutting
edges with a flat or a grinder.
3.Start it again
then stop it .
4. Sharpen the side blade as described in step 2.
5. At last coincide the blade ,and starpen the top of the blade.
Muffler
Every fifty hours, please remove the muffler, clear the inner carbon deposit
with screw driver, at the same time clean the carbon from the exhaust port.
Long time storage
IMPORTANT
1. While cleaning the machine, inspect every part for damage or loose, if find,
repair it before next use.
2. Empty the fuel tank completely, run the engine until it stops from lack of
fuel.
3. Remove the spark plug and put in two stroke oil in the engine. Pull the
starting ropes two to three times, replace the plug and stop it at the
contraction position.
4. Apply anti-rust oil to the metal parts such as the throttle wire .put the
cover on the blade and keep it indoors avoiding being damp.
stagger the blade for 2mm,
Aged fuel is one of major causes of engine starting
foilure.
Do not tight the tank lid too much, otherwise the
sealing ring will damage.
17
OWNER'S MANUAL OF SL700D/SLP600D